Supercharger Installation

WARNING: This page is about a different car, the 2002 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.

Install the supercharger gasket.

Fig 1: Supercharger Gasket
Courtesy of GENERAL MOTORS CORP.
Install the supercharger.
Install the spacers, bolts, and stud to the supercharger in the proper locations.
Tighten:

Tighten the stud/bolts to 23 N.m (17 lb ft)

Fig 2: Supercharger Spacers, Bolts, And Stud
Courtesy of GENERAL MOTORS CORP.
Install the throttle body and gasket.
Install the throttle body nuts.
Tighten:

Tighten the throttle body nuts to 10 N.m (89 lb in)

Fig 3: Throttle Body
Courtesy of GENERAL MOTORS CORP.
Install the engine wiring harness heat shield.
Install the engine wiring harness heat shield bolt and nut.
Tighten:

Tighten the engine wiring harness heat shield bolt and nut to 10 N.m (89 lb in)

Fig 4: Engine Wiring Harness Heat Shield
Courtesy of GENERAL MOTORS CORP.
Install the MAP sensor bracket.
Install the MAP sensor bracket bolts.
Tighten:

Tighten the MAP sensor bracket bolts to 30 N.m (22 lb ft)

Fig 5: MAP sensor bracket
Courtesy of GENERAL MOTORS CORP.
Install the vacuum block.
Install the vacuum block bolts.
Tighten:

Tighten the vacuum block bolts to 10 N.m (89 lb in)
Install the boost solenoid.
Install the boost solenoid bolts.
Tighten:

Tighten the boost solenoid bolts to 26 N.m (19 lb ft)
Install the regulator valve and harness bolt.
Install the booster bypass.
Install the booster bypass nut.
Tighten:

Tighten the booster bypass nut to 10 N.m (89 lb in)

Fig 6: Booster Bypass
Courtesy of GENERAL MOTORS CORP.
Install the fuel rail.
Install the fuel rail nuts and stud.
Tighten:

Tighten the fuel rail nuts and stud to 10 N.m (89 lb in)

Fig 7: Fuel Rail
Courtesy of GENERAL MOTORS CORP.
Install the vacuum line to the fuel rail.
Install the spark plug wires.