Rotating the Engine for Service Access
WARNING: This page is about a different car, the 2002 Buick Regal. However, it is still accessible from the selected car via links, so may be relevant.
Tools Required: J 41131 Engine Tilt Strap
- Disconnect the intake air temperature (IAT) sensor electrical connector.
- Remove the air inlet duct from the throttle body.
- Apply the parking brake.
- Put the transaxle in the Neutral position.
- Remove the engine mount struts. Refer to Engine Mount Strut Replacement - Right or Engine Mount Strut Replacement - Left
- Install the J 41131 to the left strut mount bracket and the upper radiator support.
- Rotate the engine forward for component access.