Engine Front Cover Installation (W Car)

WARNING: This page is about a different car, the 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Install the engine front cover gasket.
Apply sealer GM P/N United States 12346004, GM P/N Canada 10953480 or equivalent to both sides of the lower tabs of the engine front cover gasket.

Fig 1: Engine Front Cover Gasket (W Car)
Courtesy of GENERAL MOTORS CORP.
Install the engine front cover.
Install the engine front cover bolts (3).
Tighten:

Tighten the engine front cover bolts (3) to 55 N.m (41 lb ft)
Install the engine front cover bolts (1).
Tighten:

Tighten the engine front cover bolts (1) to 55 N.m (41 lb ft)
Install the engine front cover bolts (2).
Tighten:

Tighten the engine front cover bolts (2) to 27 N.m (20 lb ft)

Fig 2: Engine Front Cover Bolts (W Car)
Courtesy of GENERAL MOTORS CORP.
Install the crankshaft position sensor wiring bracket.
Install the crankshaft position sensor wiring bracket bolt.
Tighten:

Tighten the crankshaft position sensor wiring bracket bolt to 40 N.m (30 lb ft)

Fig 3: Crankshaft Position Sensor Wiring Bracket
Courtesy of GENERAL MOTORS CORP.