LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 382 (Engine Mechanical - 2.2L) >> Removal And Installation >> In-Vehicle >> Engine Drive Belt And TENSIONER Replacement >> Removal

Engine Drive Belt And TENSIONER Replacement: Removal

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: THE TENSIONER ASSEMBLY IS NOT SERVICEABLE. TO AVOID INJURY, DO NOT DISASSEMBLE TENSIONER.
  1. Disconnect negative battery cable.
  2. Raise vehicle on hoist.
  3. Remove right wheel and splash shield.
  4. Install Accessory Belt Tensioner Unloader J44811 onto tensioner.
  5. Remove accessory drive belt.
    Fig 1: Installing Accessory Belt Tensioner Unloader
    G01039280Courtesy of GENERAL MOTORS CORP.

    IMPORTANT:  To remove tensioner bolt, an access hole has been provided through the inner and outer engine rail.

  6. Remove tensioner bolt.
    Fig 2: Removing Tensioner Bolt
    G01039281Courtesy of GENERAL MOTORS CORP.
  7. Remove tensioner assembly.
scientia non olet · About LEMON Manuals