Disc Brake Mounting & Hardware Inspection - Rear
WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the disc brake pad mounting hardware for the following:
- Missing Mounting Hardware
- Excessive Corrosion
- Bent Mounting Tabs
- Looseness At The Caliper Mounting Bracket
- Looseness At The Disc Brake Pads
- If any of the conditions listed are found, the disc brake pad mounting hardware requires replacement. Ensure the disc brake pads are held firmly in place on the caliper mounting bracket, yet slide easily on the mounting hardware without binding.
- Inspect the caliper bolts for the following:
- Binding
- Seizing
- Looseness In The Caliper Mounting Bracket
- Bent Or Damaged Caliper Bolts
- Cracked Or Torn Boots
- Missing Boots
- Bent Or Damaged Caliper Mounting Bracket