LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Disc Brakes & Drum Brakes) >> Symptom Testing >> Brake Warning Indicator Always On

Brake Warning Indicator Always On

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you perform the Hydraulic Brake Diagnostic System Check? If so, go to next step. If not, go to DIAGNOSTIC SYSTEM CHECK  .
  2. Turn ON the ignition, with the engine OFF. Release the park brake. With a scan tool, observe the Park Brake Telltale parameter in the Instrument Panel Cluster data list. Does the scan tool indicate that the Park Brake Telltale parameter is Off? If so, condition is intermittent. If not, go to next step.
  3. Turn OFF the ignition. Disconnect the park brake switch. Turn ON the ignition, with the engine OFF. With a scan tool, observe the Park Brake Telltale parameter. Does the scan tool indicate that the Park Brake Telltale parameter is Off? If so, go to step  5 . If not, go to next step.
  4. Test the signal circuit of the park brake switch for a short to ground. Did you find and correct the condition? If so, go to step  9 . If not, go to step  6 .
  5. Inspect for poor connections at the harness connector of the park brake switch. Did you find and correct the condition? If so, go to step  9 . If not, go to step  7 .
  6. Inspect for poor connections at the harness connector of the instrument cluster (IPC). Did you find and correct the condition? If so, go to step  9 . If not, go to step  8 .
  7. Replace the park brake switch. See PARK BRAKE WARNING LAMP SWITCH  under REMOVAL & INSTALLATION. After repairs are complete, go to step  9 .
  8. Replace the instrument cluster (IPC). See appropriate INSTRUMENT PANELS article in ACCESSORIES & EQUIPMENT. After repairs are complete, go to next step.
  9. Operate the system in order to verify the repair. Did you correct the condition? If so, then system is okay. If system is not okay, go to step  2 .
scientia non olet · About LEMON Manuals