LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Park Brake Cable >> Installation

Rear Park Brake Cable: Installation

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the park brake cable into the support bracket and install the cable retaining pin. Install the park brake cable to the actuator lever. Connect the rear cable to the front cable.
  2. For the right rear cable, connect the cable to the clip. For the left rear cable, install the equalizer stud to the equalizer nut, which is part of the equalizer assembly. Adjust the park brake. Lower the vehicle.


  1. Install the rear park brake cable into the backing plate. Connect the rear park brake cable to the park brake lever. Connect the rear park brake cable to the front cable.
  2. For the right rear cable, connect the cable to the clip. For the left rear cable, install the equalizer stud to the equalizer nut, which is part of the equalizer assembly.
  3. Adjust the park brake. Install the rear brake drum. Install the rear tire and wheel. Tighten to specification. See TORQUE SPECIFICATIONS  . Lower the vehicle. Lower the vehicle.
scientia non olet · About LEMON Manuals