LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Park Brake Cable Equalizer >> Removal

Park Brake Cable Equalizer: Removal

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Remove the tire and wheel. Remove the rear brake caliper bracket with the brake caliper. See REAR BRAKE CALIPER BRACKET  . Remove the rear brake rotor. See REAR BRAKE ROTOR  .
  2. Loosen the park brake cable equalizer nut. Remove the park brake cable from the park brake actuator lever. See Fig 1 . Remove the park brake cable bracket. Remove the rear wheel hub and bearing. Remove the park brake actuator.
Fig 1: Removing/Installing Park Brake Cable From Park Brake Actuator
G00307638Courtesy of GENERAL MOTORS CORP.