LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Park Brake Actuator >> Removal

Park Brake Actuator: Removal

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Remove the rear wheels and tires. Relieve the park brake system tension at the equalizer assembly. Remove the rear caliper bracket.
  2. Remove the rear rotor. Disconnect and remove the rear park brake cable from the bracket at the rear wheel. Disconnect the park brake cable return spring from the park brake actuator and bracket at the rear wheel. Remove the rear hub. The rear hub, backing plate, park brake cable bracket, and park brake actuator will be removed as an assembly.
  3. Remove the 2 retainers and the park brake cable bracket from the park brake actuator. Position the rear hub aside. Remove the park brake shoe and actuator from the backing plate. Separate the actuator from the park brake shoe.
scientia non olet · About LEMON Manuals