LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Park Brake Actuator >> Installation

Park Brake Actuator: Installation

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the actuator to the park brake shoe. Install the park brake shoe and actuator onto the backing plate. Position the park brake shoe, actuator, and backing plate over the rear hub.
  2. Install the park brake cable bracket and the 2 retainers. Install the rear hub. The rear hub, backing plate, park brake cable bracket, and park brake actuator will be installed as an assembly. Install and connect the rear park brake cable to the bracket at the rear wheel.
  3. Connect the park brake cable return spring to the park brake actuator and bracket at the rear wheel. Install the rear rotor. Install the rear caliper bracket. Install the rear wheels and tires. Tighten to specification. See TORQUE SPECIFICATIONS  . Adjust the park brake system. Lower the vehicle.
scientia non olet · About LEMON Manuals