LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Master Cylinder >> Installation

Master Cylinder: Installation

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Bench bleed the master cylinder. See MASTER CYLINDER BLEEDING  under BLEEDING BRAKE SYSTEM. Install the master cylinder to the brake booster. Install the master cylinder mounting nuts. Tighten nuts to specifications. See TORQUE SPECIFICATIONS  .
  2. Remove the plugs from the brake pipes. Connect the brake pipes to the master cylinder. Tighten the fittings to specifications. See TORQUE SPECIFICATIONS  . Connect the electrical connector to the brake fluid level sensor. Bleed the hydraulic brake system. See BLEEDING BRAKE SYSTEM  .
scientia non olet · About LEMON Manuals