LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Master Cylinder Reservoir >> Removal

Master Cylinder Reservoir: Removal

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Brake master cylinder From the vehicle. See MASTER CYLINDER  . Clamp the flange on the master cylinder body in a vise. Drive out the master cylinder reservoir pins.
  2. Remove the master cylinder reservoir by pulling the reservoir straight up and away from the cylinder body. Remove the master cylinder reservoir grommets from the grooves in the reservoir. Discard the grommets. See Figure
  3. Inspect the reservoir for cracks or deformation. Replace the reservoir if necessary. Use clean denatured alcohol to clean the reservoir. Use non-lubricated compressed air to dry the reservoir.
scientia non olet · About LEMON Manuals