LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Disc Brakes & Drum Brakes) >> Overhaul >> Rear Brake Caliper >> Reassembly

Rear Brake Caliper: Reassembly

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bleeder valve and the bleeder valve cap to the caliper housing. See Fig 1 . Install a new lubricated piston seal to the caliper bore groove. Ensure that the piston seal is not twisted.
  2. Install the lubricated piston boot onto the brake caliper piston. Lubricate the brake caliper piston with clean brake fluid. Install the brake caliper piston with the brake caliper piston boot into the bore of the caliper. Push the brake caliper piston to the bottom of the bore. See Fig 1 .
  3. Install the retaining ring that secures the dust boot to the caliper housing. Install the brake caliper.
Fig 1: Exploded View Of Rear Caliper Assembly
G00076376Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals