LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 374 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> 2003 Models >> Removal

2003 Models: Removal

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: If you are replacing the wheel(s), the wheel stud(s), the wheel nut(s) or the wheel bolt(s), install only new GM original equipment parts. Installation of used parts or non-GM original equipment parts may cause the wheel to loosen, loss of tire air pressure, poor vehicle handling and loss of vehicle control resulting in personal injury.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  3. For domestic vehicles, remove the brake drum. Refer to BRAKE DRUM . For export vehicles, remove the rear brake rotor. Refer to REAR BRAKE ROTOR .
  4. Use the J-6627-A in order to extract the stud (1) from the hub (2).
    Fig 1: Using J-35917 To Press Out Wheel Stud
    G00371037Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals