Rear FWD/Drum: Removal

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
Remove the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
Remove the brake drum. Refer to following:
- For 2003 models, see BRAKE DRUM .
Remove and DISCARD the wheel bearing/hub bolts.

Fig 1: Removing Wheel Bearing/Hub Bolts (FWD)
Courtesy of GENERAL MOTORS CORP.
Remove the wheel bearing/hub.
Disconnect the wheel speed sensor electrical connector (2).

Fig 2: Identifying Wheel Speed Sensor Connector
Courtesy of GENERAL MOTORS CORP.