LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 374 (Rear Suspension System) >> Repair Instructions >> Coil Spring Replacement >> FWD With Axle >> Removal

FWD With Axle: Removal

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: When removing the rear springs, do not use a twin-post type hoist. The swing arch tendency of the rear axle assembly when certain fasteners are removed may cause it to slip from the hoist which may cause personal injury.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the brake hose bracket screw from the control arm.
  3. Use the utility stand in order to support the center of the rear axle.
  4. Remove the shock absorber lower bolts and nuts. Refer to SHOCK ABSORBER REPLACEMENT .
  5. Remove the rear axle tie rod from the rear axle. Refer to TIE ROD REPLACEMENT .
    CAUTION: Do not suspend the rear axle by the brake hoses. Damage to the brake hoses may result.
  6. Use the utility stand in order to lower the rear axle.
    CAUTION: Care should be taken to avoid chipping or scratching the spring coating when handling the rear suspension coil spring. Damage to the coating can cause premature failure.
    Fig 1: Identifying Coil Springs & Insulators
    G00371030Courtesy of GENERAL MOTORS CORP.
  7. Remove the springs (4) and the insulators (5).
scientia non olet · About LEMON Manuals