LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 373 (Rear Suspension System) >> Repair Instructions >> Tie Rod Replacement (Front Wheel Drive) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. If the vehicle is equipped with automatic level control, perform the following steps:
    1. Disconnect the automatic level control sensor electrical connector.
      2. NOTE: Do NOT disconnect the automatic level control sensor link from the sensor arm.
    2. Disconnect the height sensor link from the rear axle tie rod.
  3. Remove the rear axle tie rod bolts.
    Fig 1: Rear Axle Tie Rod Bolts
    G00357864Courtesy of GENERAL MOTORS CORP.
  4. Remove the rear axle tie rod from the vehicle.
scientia non olet · About LEMON Manuals