LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 373 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement (All Wheel Drive) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Disconnect the height sensor from the lower control arm as necessary.
  3. Remove the stabilizer shaft insulator bracket bolts and nuts. See Figure.
  4. Remove the stabilizer shaft insulator brackets along with the Automatic Level Control (ALC) position sensor, if necessary.
  5. Remove the stabilizer shaft insulators from the stabilizer shaft.
scientia non olet · About LEMON Manuals