LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 373 (Rear Suspension System) >> Repair Instructions >> Rear Wheel Bearing/Hub Replacement (AWD - Disc) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wheel bearing/hub assembly (1) on to the knuckle (2). See Figure.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the bolts (1) into the wheel bearing/hub assembly. See Figure. Tighten the wheel bearing/hub bolts to 130 N.m (96 lb ft).
  3. Install the tire and wheel.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals