LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 372 (Suspension - General Diagnosis) >> Diagnostic Information And Procedures >> Suspension Bottoms

Suspension Bottoms

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.

DEFINITION: A loud bang or thump that can usually be felt and/or heard when the vehicle is driven over bumps. This condition is commonly noticed when the vehicle trim height is too low.

  1. Did you review the General Description and perform the necessary inspections? If so, go to next step. If not, see SYMPTOMS - SUSPENSION GENERAL DIAGNOSIS  .
  2. Verify that the suspension bottoms. Does the vehicle operate normally? If so, system is OK. If not, go to next step.
  3. Check for vehicle overloading. Is the vehicle overloaded? If so, go to step  6 . If not, go to next step.
  4. Inspect the vehicle trim height. Refer to TRIM HEIGHT INSPECTION PROCEDURE  . Is the vehicle trim height incorrect?
  5. Inspect the struts and shock absorbers. Refer to STRUTS OR SHOCK ABSORBERS ON-VEHICLE TESTING  . Are the components in need of replacement? If so, go to step  8 . If not, go to step  9 .
  6. Remove the excess weight from the vehicle. Did you remove the excess weight from the vehicle? If so, go to step  9 .
  7. Correct the vehicle trim height. Refer to TRIM HEIGHT INSPECTION PROCEDURE  . After repairs are complete, go to step  9 .
  8. Replace the components as necessary. After repairs are complete, go to next step.
  9. Operate the vehicle in order to verify the repair. Did you correct the condition? If so, system is OK. If not, go back to step  3 .