LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 371 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation

Wheel Stud Replacement: Installation

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new wheel stud from the back side of the wheel bearing/hub.
  2. Install three flat washers (1) to the wheel stud (3).
    Fig 1: Installing New Wheel Stud
    G00371038Courtesy of GENERAL MOTORS CORP.
  3. Install a hex nut (2) to the wheel stud (3).
  4. Tighten the hex nut until the stud head is fully seated in the wheel bearing/hub flange.
  5. Remove the hex nut and the washers from the wheel stud.
  6. For domestic vehicles, install the brake drum. Refer to BRAKE DRUM . For export vehicles, install the rear brake rotor. Refer to REAR BRAKE ROTOR .
  7. Install the tire and wheel. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in TIRES AND WHEELS .
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals