LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 371 (Rear Suspension System) >> Repair Instructions >> Wheel Bearing/Hub Replacement - Rear Front Wheel Drive/Drum >> Removal

Wheel Bearing/Hub Replacement - Rear Front Wheel Drive/Drum: Removal

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the tire and wheel.
  3. Remove the brake drum. Refer to BRAKE DRUM .
  4. Remove and DISCARD the wheel bearing/hub bolts.
  5. Remove the wheel bearing/hub.
  6. Disconnect the wheel speed sensor electrical connector (2).
    Fig 1: Locating Wheel Speed Sensor Electrical Connector
    G00371013Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals