Tie Rod Replacement All Wheel Drive: Installation
WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
- Install the tie rod.NOTE: Refer to FASTENER NOTICE .
- Install the tie rod nut. Tighten the tie rod nut to 80 N.m (59 lb ft).
- Install the tie rod bolt. Tighten the tie rod bolt to 85 N.m (63 lb ft).
- Adjust the rear toe angle. Refer to SPECIFICATIONS .
- Lower the vehicle.