Shock Absorber Replacement Front Wheel Drive: Installation
WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
- Install the shock absorber.NOTE: Refer to FASTENER NOTICE .
- Install the shock absorber bolts and nuts. Tighten the shock absorber nuts to 85 N.m (63 lb ft).
- If the vehicle is equipped with automatic level control, install the air tube connector to the shock absorber.
- Remove the support from the rear axle.
- Lower the vehicle.