LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 371 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement All Wheel Drive >> Installation

Shock Absorber Replacement All Wheel Drive: Installation

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shock absorber.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the shock absorber upper bolt (1). Tighten the shock absorber bolt (2 and 3) to 85 N.m (63 lb ft).
  3. Install the shock absorber lower nut. Tighten the shock absorber nut to 85 N.m (63 lb ft).
  4. If the vehicle is equipped with automatic level control, install the air tube connector to the shock absorber.
  5. Remove the utility stand.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals