LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 371 (Rear Suspension System) >> Repair Instructions >> Rear Axle Lower Control Arm Bushing Replacement Rear Bushing - All Wheel Drive >> Removal

Rear Axle Lower Control Arm Bushing Replacement Rear Bushing - All Wheel Drive: Removal

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the wheel and tire assemblies.
  3. Remove the coil spring. Refer to COIL SPRING REPLACEMENT ALL WHEEL DRIVE .
  4. Remove the lower control arm to crossmember mounting bolts (1, 5). Refer to Figure.
  5. Measure and record the installation depth of the bushing in the control arm.
  6. Make a mark on the control arm in line with the flat edge of the bushing flange in order to identify the rotational orientation of the bushing in the control arm.
  7. Use a press in order to remove the bushing.
scientia non olet · About LEMON Manuals