LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 371 (Rear Suspension System) >> Repair Instructions >> Rear Axle Lower Control Arm Bushing Replacement Front Bushing - All Wheel Drive >> Removal

Rear Axle Lower Control Arm Bushing Replacement Front Bushing - All Wheel Drive: Removal

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the wheel and tire assemblies.
  3. Use a utility stand in order to support the lower control arm.
  4. Remove the coil spring (2). Refer to Figure.
  5. Make a mark on the lower control arm at the cam indicator. Refer to Figure.
  6. Remove the lower control arm to crossmember mounting bolts (1, 5). Refer to Figure.
    NOTE: Identify the orientation of the voids in the bushing to the crossmember.
  7. Remove the bushing from the crossmember.
    Fig 1: Removing Bushing From Crossmember
    G00371026Courtesy of GENERAL MOTORS CORP.
  8. In order to remove the bushing from the crossmember, use the following tools from the J-21474-01 :
    • J-6627-4 (1)
    • J-45411 (2)
    • J-21474-8 (3)
    • J-21474-4 (4)
    Fig 2: Identifying J-21474-01 Components To Remove Crossmember Bushing
    G00371027Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals