LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 371 (Rear Suspension System) >> Repair Instructions >> Control Arm Bushing Replacement >> Removal

Control Arm Bushing Replacement: Removal

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Use a utility stand in order to support the control arm forward of the coil spring.
  3. Remove the control arm bolts from the rear axle. Refer to REAR AXLE REPLACEMENT .
  4. Use the utility stand in order to lower the rear axle enough to gain access to the control arm bushing.
  5. Mark the orientation of the control arm bushing in the lower control arm.
    Fig 1: Marking Orientation Of Control Arm Bushing
    G00371032Courtesy of GENERAL MOTORS CORP.
  6. Use the J-28685 and the J-9519-E in order to remove the control arm bushing.
    Fig 2: Using J-28685 & J-9519-E To Remove Control Arm Bushing
    G00371033Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals