Control Arm Bushing Replacement: Installation

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.

Align the flat edge of the bushing with the mark on the control arm in order to install the bushing at a 45 degree angle.

Fig 1: Aligning Bushing At 45 Degree Angle For Installation
Courtesy of GENERAL MOTORS CORP.
Use the J-28685 and the J-9519-E in order to install the control arm bushing.

Fig 2: Using J-28685 & J-9519-E To Install Control Arm Bushing
Courtesy of GENERAL MOTORS CORP.

NOTE: The bushing must extend 9.8 mm (0.39 in) from the control arm.

Fig 3: Measuring Control Arm Bushing Depth
Courtesy of GENERAL MOTORS CORP.
The bushing is installed to the proper depth when the end of the bushing is aligned with the indicator line on the J-28685.
Use the utility stand in order to raise the rear axle.
Install the control arm bolt to the rear axle. Refer to REAR AXLE REPLACEMENT .
Remove the utility stand.
Lower the vehicle.