Coil Spring Replacement Front Wheel Drive Without Axle: Installation
WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
- Install the coil spring (2). Refer to Figure.
- Use the utility jack in order to raise the lower control arm and load the suspension.
- Use the J-41820 in order to connect the ball joint to the knuckle. Refer to Figure.
- Install the stabilizer link to the lower control arm.
- Use the utility jack in order to support the lower control arm.
- Install the ABS electrical connector mounting bracket.
- Connect the ABS electrical connector.
- Install the brake caliper mounting bracket.
- Install the parking brake cable mounting bracket.
- Install the brake calipers. Refer to REAR BRAKE CALIPER .
- Install the wheel and tire assemblies. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in TIRES AND WHEELS .
- Lower the vehicle.