LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 371 (Rear Suspension System) >> Repair Instructions >> Coil Spring Replacement Front Wheel Drive With Axle >> Removal

Coil Spring Replacement Front Wheel Drive With Axle: Removal

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: When removing the rear springs, do not use a twin-post type hoist. The swing arch tendency of the rear axle assembly when certain fasteners are removed may cause it to slip from the hoist which may cause personal injury.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the brake hose bracket screw from the control arm.
  3. Use the utility stand in order to support the center of the rear axle.
  4. Remove the shock absorber lower bolts and nuts. Refer to SHOCK ABSORBER REPLACEMENT FRONT WHEEL DRIVE .
  5. Remove the rear axle tie rod from the rear axle. Refer to TIE ROD REPLACEMENT FRONT WHEEL DRIVE .
    CAUTION: Do not suspend the rear axle by the brake hoses. Damage to the brake hoses may result.
  6. Use the utility stand in order to lower the rear axle.
    CAUTION: Care should be taken to avoid chipping or scratching the spring coating when handling the rear suspension coil spring. Damage to the coating can cause premature failure.
  7. Remove the springs (4) and the insulators (5).
    Fig 1: Identifying Coil Springs & Insulators
    G00371030Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals