LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 368 (Suspension System General Diagnosis) >> Diagnostic Information >> Struts Or Shock Absorbers On-Vehicle Testing

Struts Or Shock Absorbers On-Vehicle Testing

WARNING: This page is about a different car, the 2003 GMC Jimmy and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Did you review the General Description and perform the necessary inspections? If yes, go to next step. If no, go to SYMPTOMS - SUSPENSION GENERAL DIAGNOSIS .
  2. Verify that the customer's concern is present. Does the vehicle operate normally? If yes, system is okay. If no, go to next step.
  3. NOTE: A light film of oil on the top portion of the shock reservoir is normal.
  4. Inspect each shock absorber for external fluid leakage. Is a strut or shock absorber leaking? If yes, go to step  5. If no, go to next step.
  5. Use your hands in order to lift up and push down each corner of the vehicle 3 times. Remove your hands from the vehicle. Locate a shock or strut that exceeds 2 cycles. Did you locate shock or strut that exceeds 2 cycles? If yes, go to next step. If no, go to step  6.
  6. NOTE: Inspect the vehicle trim height in order to correct any possible causes of shock/strut failures. Refer to TRIM HEIGHT INSPECTION PROCEDURE .
  7. Replace the shock absorber. After replacing shock absorber, go to next step.
  8. Operate the vehicle in order to verify the repair. Did you correct the condition? If yes, system is okay. If no, go to step  3.