LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 367 (Rear Suspension System) >> Repair Instructions >> Stabilizer Shaft Replacement (4-Door Utility) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle.
  2. Remove the stabilizer links to stabilizer shaft nuts and bolts.
    Fig 1: Removing Stabilizer Links-To-Stabilizer Shaft Nut & Bolt
    G00357816Courtesy of GENERAL MOTORS CORP.
  3. Remove the stabilizer shaft U-bolts and nuts.
    Fig 2: Removing Stabilizer Shaft U-Bolt
    G00357773Courtesy of GENERAL MOTORS CORP.
  4. Remove the stabilizer shaft U-bolts and clamps.
  5. Remove the stabilizer shaft insulators.
  6. Remove the stabilizer shaft.
scientia non olet · About LEMON Manuals