LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 365 (Rear Suspension) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Removal

Stabilizer Shaft Link Replacement: Removal

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Loosen the stabilizer bar clamp bolts.
    NOTE: Hold the ball shaft secure with a TORX® bit, when removing the nut.
  3. Remove the stabilizer link to stabilizer bar nut.
    NOTE: When disconnecting the stabilizer link, hold the link with a wrench to prevent turning.
    Fig 1: Holding Stabilizer Ball Shaft Secure
    G00370963Courtesy of GENERAL MOTORS CORP.
  4. Remove the stabilizer link to control arm nut.
    Fig 2: Holding Stabilizer Link To Remove Control Arm Nut
    G00370964Courtesy of GENERAL MOTORS CORP.
  5. Remove the stabilizer link from the vehicle.
scientia non olet · About LEMON Manuals