LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 365 (Rear Suspension) >> Repair Instructions >> Knuckle Replacement >> Removal

Knuckle Replacement: Removal

WARNING: This page is about a different car, the 2003 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the tire and wheel.
  3. Remove the wheel bearing/hub assembly. Refer to WHEEL BEARING/HUB REPLACEMENT - REAR .
  4. Remove the upper control arm to knuckle bolt and nut.
    Fig 1: Removing Upper Control Arm-To-Knuckle Nut & Bolt
    G00370952Courtesy of GENERAL MOTORS CORP.
  5. Remove the lower control arm to knuckle bolt and nut.
    Fig 2: Removing Lower Control Arm-To-Knuckle Bolt & Nut
    G00370953Courtesy of GENERAL MOTORS CORP.
  6. Remove the toe link to knuckle bolt and nut.
    Fig 3: Removing Toe Link-To-Knuckle Bolt & Nut
    G00370954Courtesy of GENERAL MOTORS CORP.
  7. Remove the trailing blade to knuckle bolts.
    Fig 4: Removing Trailing Blade-To-Knuckle Bolts
    G00370955Courtesy of GENERAL MOTORS CORP.
  8. Remove the knuckle from the vehicle.
scientia non olet · About LEMON Manuals