Caliper (Front): Installation
WARNING: This page is about a different car, the 2003 Buick Regal, 2003 Buick Century, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
- If reusing the brake caliper pin bolts, wipe away any debris and old lubricant with a with a clean shop cloth.
- Apply lubricant, GM P/N 18047666, or equivalent, to the brake caliper pin bolts. Apply a thin layer to the pin bushing and to the caliper pin bolt shank. Ensure that there is not a buildup of excess lubricant at the end of the leading caliper pin, in front of the bushing.
- Install the caliper over the rotor and onto the caliper bracket.
- Install the caliper pin bolts. The leading caliper pin bolt, or top bolt, has a bushing as part of the assembly. The trailing caliper pin bolt, or bottom bolt, is a solid design. Ensure that the bolt boots fit securely in the groove of the caliper pin bolts. If the boots are damaged, they must be replaced. Tighten the bolts to specification. See TORQUE SPECIFICATIONS .
- Assemble the brake hose bolt and the NEW copper brake hose gaskets to the brake hose.
- Install the brake hose-to-caliper bolt to the brake caliper. Tighten the bolt to specification. See TORQUE SPECIFICATIONS .
- Remove the 2 wheel lug nuts retaining the rotor to the hub.
- Install the front tire and the wheel assembly.
- Lower the vehicle.
- Fill the master cylinder to the proper level with clean brake fluid.
- Bleed the brake system. See MANUAL BLEEDING under BLEEDING BRAKE SYSTEM.
- Inspect the hydraulic brake system for brake fluid leaks. See Fig 1 .