LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 36 (Disc Brakes & Drum Brakes) >> Overhaul >> Front Caliper >> Assembly

Front Caliper: Assembly

WARNING: This page is about a different car, the 2003 Buick Regal, 2003 Buick Century, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new piston seal with Delco Supreme 11(R), GM P/N 12377967, or equivalent DOT-3 brake fluid from a clean, sealed brake fluid container.
  2. Install the lubricated, new piston seal into the caliper bore.
  3. Install the caliper piston into the caliper bore. Press the piston to the bottom of the bore.
  4. Install the new piston dust boot seal over the piston.
  5. Use Caliper Piston Seal Installer (J-35777) to fully seat the caliper piston seal into the counterbore.
  6. Install the bleeder valve and cap to the caliper and tighten the valve securely.
  7. Install the front brake caliper to the vehicle. See CALIPER REPLACEMENT (FRONT)  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals