LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 353 (Disc Brakes) >> Removal & Installation >> Rear Brake Hose >> Removal

Rear Brake Hose: Removal

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the rear tire and wheel assembly.
  3. Clean all dirt and foreign material from the brake hoses and brake pipe fitting.
    NOTE: Install a rubber cap or plug to the exposed brake pipe fitting end to prevent brake fluid loss and contamination.
  4. Use a backup wrench on the hose fitting, disconnect the brake pipe fitting from the brake hose, then cap or plug the brake pipe fitting end. DO NOT bend the brake pipe or the bracket.
  5. Remove the brake hose retaining clip from the hose mounting bracket.
  6. Remove the hose from the bracket.
  7. Remove the brake hose to caliper bolt from the brake caliper.
  8. Remove the brake hose from the brake caliper.
  9. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper and/or the brake hose end.
scientia non olet · About LEMON Manuals