LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 353 (Disc Brakes) >> Removal & Installation >> Park Brake Actuator >> Installation

Park Brake Actuator: Installation

WARNING: This page is about a different car, the 2003 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the actuator to the park brake shoe. See Figure . Install the park brake shoe and actuator onto the backing plate.
  2. Position the park brake shoe, actuator, and backing plate over the rear hub.
  3. Install the park brake cable bracket and the 2 retainers. Tighten the park brake cable bracket retainers to specification. See TORQUE SPECIFICATIONS  .
  4. Install the rear hub. See HUB & BEARING ASSEMBLY under REMOVAL & INSTALLATION in REAR article in SUSPENSION. The rear hub, backing plate, park brake cable bracket, and park brake actuator will be installed as an assembly.
  5. Install and connect the rear park brake cable to the bracket at the rear wheel. See PARK BRAKE CABLE  .
  6. Connect the park brake cable return spring to the park brake actuator and bracket at the rear wheel.
  7. Install the rear rotor. See REAR BRAKE ROTOR  .
  8. Install the rear tire and wheel assemblies. Tighten wheel lug nuts to specification. See TORQUE SPECIFICATIONS  .
  9. Adjust the park brake system. See PARK BRAKE ADJUSTMENT  under ADJUSTMENTS & INSPECTIONS.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals