EVA Vibration Sensor-To-Component Attachment

WARNING: This page does not describe the selected car, but rather 58 other vehicles, including the 2003 Saturn Vue, 2003 Saturn L300, 2003 Saturn Ion 3, 2003 Saturn Ion 2, and 2003 Saturn Ion 1. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The EVA vibration sensor must be attached to vehicle components in the manner indicated in order to achieve accurate frequency readings of the vibration disturbance.

The vibration sensor of the EVA is designed to pickup disturbances which primarily occur in the vertical plane, since most vibrations are felt in that same up-and-down direction. The EVA vibration sensor is therefore directional sensitive and must be attached to vehicle components such that the side of the sensor marked UP is always facing upright and the sensor body is as close to horizontal as possible. The sensor must be installed in the exact same position each time tests are repeated or comparisons are made to other vehicles.

The EVA vibration sensor can be attached to vehicle components in various ways. For non-ferrous surfaces, such as the shroud of a steering column, the sensor can be attached using putty, or hook and loop fasteners. For ferrous surfaces, the sensor can be attached using a magnet supplied with the sensor.