LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 336 (Differential) >> Removal & Installation >> Torque Tube Assembly >> Installation

Torque Tube Assembly: Installation

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Required Tools: Seal Installer (J-44915).
  1. Using Seal Installer, install a NEW oil seal to the drive pinion housing. See Figure . Align the splines on the torque tube shaft to the differential pinion shaft. Install the torque tube to the differential.
  2. Install the bolts to the torque tube bracket. See Figure . Tighten the torque tube bracket bolts to specification. See TORQUE SPECIFICATIONS  . Tighten the torque tube-to-bracket through-bolt and nut to specification. Install the torque tube-to-differential carrier bolts. Tighten the bolts to specification.
  3. Install the front drive shaft. Tighten the mounting bolts to specification. See TORQUE SPECIFICATIONS  . Remove the jack stand from under the front of the rear differential. Lower the vehicle.
scientia non olet · About LEMON Manuals