Front Axle Shaft Tripot Joint
WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
The front axle shaft tripot joint is made without an over-extension limitation retainer. The joint is constructed as follows:
- The left front axle shaft has a female spline. The female spline installs over a stub shaft that protrudes from the transaxle.
- The right front axle shaft has a male spline. The right front axle shaft uses a barrel-type retaining ring in order to interlock with the transaxle gears.