LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 332 (Disc Brakes) >> Removal & Installation >> Rear Wheel Bearing/Hub >> Removal

Rear Wheel Bearing/Hub: Removal

WARNING: This page is about a different car, the 2003 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly.
  3. Disconnect the wheel speed sensor electrical connector.
  4. Disconnect the Real Time Damping (RTD) position sensor link, if equipped.
  5. Remove the brake caliper and rotor. See REAR BRAKE ROTOR .
  6. Remove the shock absorber solenoid electrical connector, if equipped.
  7. Separate the outer tie rod end from the suspension knuckle.
  8. Remove the axle shaft spindle nut retainer, the axle shaft spindle nut and the washer.
  9. Separate the upper control arm from the suspension knuckle.
  10. Separate the suspension knuckle from the lower control arm ball joint stud.
  11. Remove the suspension knuckle from the vehicle.
  12. Remove the wheel hub mounting bolts.
  13. Remove the hub and bearing assembly from the suspension knuckle.
scientia non olet · About LEMON Manuals