LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 328 (Disc Brakes & Drum Brakes) >> Overhaul >> Brake Caliper - Front >> Assembly

Brake Caliper - Front: Assembly

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bleeder valve and the bleeder valve cap to the caliper housing.
  2. Install a NEW lubricated piston seal to the caliper bore grooves. Ensure that the piston seal is not twisted.
  3. Install the lubricated boot onto the brake caliper piston.
  4. Lubricate the brake caliper piston with clean brake fluid.
  5. Install the brake caliper piston and the brake caliper piston boot into the bore of the caliper. Push the brake caliper piston to the bottom of the bore.
  6. Seat the caliper boot in the caliper housing counterbore using the Dust Boot Seal Installer (J-36349).
  7. Install the caliper. See BRAKE CALIPER  under REMOVAL & INSTALLATION.
Fig 1: Exploded View Of Single Piston Caliper Assembly
G00030580Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals