LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 327 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Disc Brake Hardware - Front Single Piston >> Installation

Disc Brake Hardware - Front Single Piston: Installation

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean area using denatured alcohol.
  2. Dry area using non-lubricated, filtered compressed air.
  3. Apply high temperature silicone brake lubricant to the brake caliper pin bolts and retainers. DO NOT apply lubricant to the brake pad hardware.
  4. Install the front brake caliper bolt, bolt sleeve and bolt sleeve bushing.
  5. Install the inner brake pad retainer spring.
  6. Install the brake pad to the brake caliper bracket. See BRAKE PADS - FRONT SINGLE PISTON CALIPER .
  7. Install the tire and wheel assembly.
  8. Lower the vehicle.
  9. With the engine running, firmly pump the brake pedal 3 times.
scientia non olet · About LEMON Manuals