LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 327 (Disc Brakes & Drum Brakes) >> Overhaul >> Brake Caliper - Front Dual Piston >> Assembly

Brake Caliper - Front Dual Piston: Assembly

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new piston seals, the caliper bores, and the pistons using clean brake fluid.
  2. Install the piston seals. Ensure that the piston seals are not twisted in the caliper bore grooves.
  3. Install the boot seals on the pistons.
  4. Install the pistons in the caliper bores.
  5. Install the bleeder valve in the caliper housing. Tighten the bleeder valve to specification. See TORQUE SPECIFICATIONS .
  6. Install the bleeder valve cap.
  7. Install the boot seals into the caliper housing bores using the Driver Handle (J-8092), and the Boot Sealer Installer (J-43885).
scientia non olet · About LEMON Manuals