LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 326 (Disc Brakes & Drum Brakes) >> Symptom Testing >> Brakes Drag

Brakes Drag

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Were you sent here from Hydraulic Brake Symptom table? If so, go to next step. If not, see DIAGNOSTIC STARTING POINT - HYDRAULIC BRAKE  under TROUBLE SHOOTING.
  2. Is the vehicle equipped with an adjustable stoplight switch and/or an adjustable cruise control release switch? If so, go to next step. If not, go to step  4 .
  3. Inspect the stoplight switch for proper adjustment to ensure that the brake pedal is fully releasing. Inspect the cruise control release switch, if equipped, for proper adjustment to ensure that the brake pedal is fully releasing. Did you find and correct a condition? If so, go to step  12 . If not, go to next step.
  4. Inspect the drum brake system for proper operation. See DRUM BRAKE SYSTEM TESTING  under SYSTEM TESTING. Did you find and correct a condition? If so, go to step  12 . If not, go to next step.
  5. Inspect the park brake system for proper operation. See PARK BRAKE SYSTEM TESTING  under SYSTEM TESTING. Did you find and correct a condition? If so, go to step  12 . If not, go to next step.
  6. Inspect the disc brake system for proper operation. See DISC BRAKE SYSTEM TESTING  under SYSTEM TESTING. Did you find and correct a condition? If so, go to step  12 . If not, go to next step.
  7. Separate the brake booster pushrod from the brake pedal. Inspect the brake corners to determine if the brake drag condition is still present. Do the brake corners still exhibit the brake drag condition? If so, go to step  9 . If not, go to next step.
  8. Replace the brake pedal assembly. Did you complete the replacement? If so, go to step  12 .
  9. Separate the master cylinder from the brake booster. Do not disconnect any brake pipes. Inspect the brake corners to determine if the brake drag condition is still present. Do the brake corners still exhibit the brake drag condition? If so, go to step  11 . If not, go to next step.
  10. Replace the brake booster assembly. Did you complete the replacement? If so, go to step  12 .
  11. Inspect the hydraulic brake system for proper operation. See HYDRAULIC BRAKE SYSTEM TESTING  under SYSTEM TESTING. Did you find and correct a condition? If so, go to next step. If not, go to DIAGNOSTIC STARTING POINT - HYDRAULIC BRAKE  under TROUBLE SHOOTING.
  12. Install or connect components that were removed or disconnected during diagnosis. Road test the vehicle in order to confirm proper operation. See BRAKE SYSTEM VEHICLE ROAD TEST  under TROUBLE SHOOTING. Is the condition still present? If so, go to step  2 . If not, then system is okay.
scientia non olet · About LEMON Manuals