Brake Fluid Loss
WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
- Were you sent here from Hydraulic Brake Symptom table? If so, go to next step. If not, see DIAGNOSTIC STARTING POINT - HYDRAULIC BRAKE under TROUBLE SHOOTING.
- Inspect the hydraulic brake system for proper operation. See HYDRAULIC BRAKE SYSTEM TESTING under SYSTEM TESTING. Did you find and correct a condition? If so, go to step 7 . If not, go to next step.
- Inspect the disc brake system for proper operation. See DISC BRAKE SYSTEM TESTING under SYSTEM TESTING. Did you find and correct a condition? If so, go to step 7 . If not, go to next step.
- Inspect the drum brake system for proper operation. See DRUM BRAKE SYSTEM TESTING under SYSTEM TESTING. Did you find and correct a condition? If so, go to step 7 . If not, go to next step.
- Separate the master cylinder from the brake booster. Do not disconnect any brake pipes. See MASTER CYLINDER under REMOVAL & INSTALLATION. Inspect the rear of the master cylinder for a brake fluid leak. Inspect for brake fluid in the power brake booster. Did you find a brake fluid leak? If so, go to next step. If not, go to DIAGNOSTIC STARTING POINT - HYDRAULIC BRAKE under TROUBLE SHOOTING.
- Replace the brake master cylinder and the power brake booster. See MASTER CYLINDER and POWER BRAKE BOOSTER under REMOVAL & INSTALLATION. Did you complete the replacement? If so, go to next step.
- Install or connect components that were removed or disconnected during diagnosis. Road test the vehicle to confirm proper operation. See BRAKE SYSTEM VEHICLE ROAD TEST under TROUBLE SHOOTING. Is the condition still present? If so, go to step 2 . If not, then system is okay.