LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 326 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Rear Park Brake Cable >> Removal (Drum)

Removal (Drum)

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Remove the rear tire and wheel. Relieve the park brake cable tension at the equalizer. Disconnect the rear cable from the front cable.
  2. For the right rear cable, disconnect the cable from the clip. For the left rear cable, fully remove the equalizer nut from the equalizer stud, which is part of the left rear cable.
  3. Remove the brake drum. See BRAKE DRUM  . Disconnect the park brake cable from the park brake lever. Remove the rear park brake cable from the backing plate using Park Brake Cable Release Tool (J-37043) and remove the cable from the vehicle.
scientia non olet · About LEMON Manuals