LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 326 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Park Brake Actuator >> Installation

Park Brake Actuator: Installation

WARNING: This page is about a different car, the 2003 Pontiac Montana, 2003 Oldsmobile Silhouette, and 2003 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Assemble the actuator to the park brake shoe. Install the park brake shoe and actuator onto the backing plate. Position the park brake shoe, actuator, and backing plate over the rear hub.
  2. Install the park brake cable bracket and the 2 retainers. Install the rear hub. The rear hub, backing plate, park brake cable bracket, and park brake actuator will be installed as an assembly. Install and connect the rear park brake cable to the bracket at the rear wheel.
  3. Connect the park brake cable return spring to the park brake actuator and bracket at the rear wheel. Install the rear rotor. See REAR BRAKE ROTOR  . Install the rear caliper bracket. See REAR BRAKE CALIPER BRACKET  . Install the rear wheels and tires. Adjust the park brake system. See DRUM PARK BRAKE ADJUSTMENT  and DISC PARKING BRAKE ADJUSTMENT  . Lower the vehicle.
scientia non olet · About LEMON Manuals